Dealer and quantity discounts available
Cart 0
Molded T-Bar Knob Fits Most Popular Reel Handles (See Description)

Molded T-Bar Knob Fits Most Popular Reel Handles (See Description)




These knobs can be used with both conventional and spinning reels.  However, extra care should be used when considering use with small spinning reels as the handle blank must have enough "meat" to support the knob's 6mm pin.

Please keep in mind that the Power Knob must be attached to your existing reel handle.  A handle blank is NOT included in this purchase.  However, if you prefer to purchase a complete Power Handle assembly, I have handle blanks for many of the most popular reels.

You are bidding for a new hard molded plastic T-Bar Power Knob. The knob incorporates a 9 degree offset to provide increased torque. There are no bearings in the knob.


To attach the knob to the reel handle:  

Remove the 2 small phillips screws and face plate from the top of the knob. This will expose a slot in the pin for a screw driver.  Unscrew the phillips screw from the bottom of the knob using a second screw driver.  Leave the washer on the exposed pin.  Use blue Loctite 242 inside the pin when attaching the pin to the handle blank to secure the screw.  Attach pin to the handle blank using 2 screw drivers.  Then replace the face plate and 2 small screws.


Mounting Screws May Be LEFT HANDED!

If Needed, Installation Notes Available Upon Request

Sales Tax: CA Residents Pay Sales Tax.

Share this Product