Direct Replacement - NO Drilling Needed
Round Aluminum Knob For Shimano Spinning Reels Fit Many of the Following Models:
Stella FB, FD & FE
Stradic FJ, CI4 & FK
Prior to your purchase, please read the notes below to ensure successful installation.
In order to determine if the replacement knob will fit your model reel, you must first remove the knob attached to you reel. If the knob can not be remove simply with a screw driver, the replacement knob can NOT be installed on you reel handle.
After removing the knob on your reel, you must inspect the spindle to confirm the following characteristics.
1. The tip of the spindle accepts a small screw.
2. The base of the spindle will accept a 5mm ID diameter Ball Bearing.
3. The spindle shaft diameter is 4mm maximum.
4. The length of the spindle shaft is between 27.5mm and 28mm.
Please feel free to contact me if you have a reel spindle which does not confirm to the 4 points shown above. I may be able to provide you with knob for your reel.
Handle Blank is NOT Included & NOT Needed.
45mm - 1.77" Round Aluminum Knob - Includes 2 Ball Bearing - No Drilling Needed.
Proper Installation Requires the Use of Loctite BLUE 242.
Attaching the Knob to the Handle Blank:
To attach the knob to the handle spindle, you must first remove the top cap of the knob.Using 2 screw drivers, remove the bottom screw and small washer from the internal shaft.
Note: The bottom screw is LEFT Handed! Place a small amount of Loctite Blue 242 into the opening of the internal shaft and on the threads of the bottom screw.
Attach the screw thru the handle blank hole into the shaft. With 2 screw drivers, tighten the 2 shaft screws from both the top and bottom. Replace the top cap.
If Needed, Installation Notes Available Upon Request
Sales Tax: CA Residents Add Sales Tax.