Dealer and quantity discounts available
Cart 0
Rum Runner's DIRECT Replacement 36mm Knob w/ 2 Bearings fits SHIMANO Stradic 4000XG Reels

Rum Runner's DIRECT Replacement 36mm Knob w/ 2 Bearings fits SHIMANO Stradic 4000XG Reels

$19.95

Direct Replacement - NO Drilling Needed

Handle is NOT needed and NOT Included.

 Round 36mm Aluminum Knob For Shimano  Reels with Handle Type "A" 

Fits Many of  the Following Models:

Stella FB, FD & FE

Stradic FJ, CI4 & FK

Sustain FG

Prior to your purchase, please read the notes below to ensure successful installation.

IMPORTANT NOTE:

In order to determine if the replacement knob will fit your model reel, you must first remove the knob attached to you reel.  If the knob can not be remove simply with a screw driver, the replacement knob can NOT be installed on you reel handle.

After removing the knob on your reel, you must inspect the spindle to confirm the following characteristics.

1. The tip of the spindle accepts a small screw.

2.  The base of the spindle will accept a 5mm ID diameter Ball Bearing.

3.  The spindle shaft diameter is 4mm maximum.

4.  The length of the spindle shaft is between 27.5mm and 28mm.

Please feel free to contact me if you have a reel spindle which does not confirm to the 4 points shown above.  I may be able to provide you with knob for your reel.

These Knobs are extremely comfortable & lightweight, about 1oz.

Proper Installation Requires the Use of Loctite BLUE 242.

Prior to the installation of the knob, the original knob must be removed from the reel handle.  All bearings and shims must also be removed.The removal of the original knob as well as the installation of the new knob requires the simple use of only a Phillips screw driver and Loctite 242 Blue, nothing more.

The following parts are included with the knob.

1.  5mm x 11mm x 3mm Ball Bearing in the base of the knob.

2. (2) 5mm x 8mm x 1mm Shims in the bottom of the spindle chamber of the knob.

3. 4mm x 9mm x 2.5mm Ball Bearing on top of the 2 shims.

4.  2.5mm screw with Loctitie Blue

Attaching the Knob to the Handle Spindle:

1.  Remove the top half of the knob and any paper found inside the spindle chamber.

2. Remove the tape from the bottom of the knob and place the knob onto the reel spindle.

3.  Place the the bottom half of the knob on the Spindle.

NOTE: Make sure the tip of the Spindle is inserted into the Top Bearing.  

If not, you must 'seat' the bearing onto the tip of the Spindle.  

The tip of the Spindle must just  pertude a  very small amount beyond the top of the bearing.

4. Place the NYLOK screw into the Spindle and tighten the screw all the way. If the Stem does not  spin freely, loosen the screw slightly until it spins.  The NYLOK screw prevents the Stem from loosening or tightening.

NOTE: It is very important to insure the screw is carefully inserted and tightened keeping it parallel with the spindle. If not the screw will become cross threaded, and a gap will appear at the base of the housing.  The best way to ensure proper insertion is to begin turning the screw in the opposite direction until you 'feel' movement of the screw.  Then screw down completely.

If Needed, Additional Installation Notes Are Available Upon Request
 
Sales Tax: CA Residents Pay Sales Tax.

Share this Product