New Light Weight 45mm - 1.77" ALUMINUM Round Power Knob with 2 Ball Bearings.
Ideal for Medium Size Spinning & Conventional Reels.
Handle Blank and Reel NOT Included.
You can use the knob only when you drill out the rivet of the original knob and attached the knob with the pin screw which is included. secure with BLUE loctite 242.
The knob has a internal pin that passes thru the handle shaft on you reels. There is also a screw then goes into the pin which is used to attach the knob to the shaft. This seems to work on all spinners and conventional reels i have encountered, but there is no guarantee.
Here is some additional information. The internal pin of the shaft is about 4mm long. Most reel handles have a handle thickness of about 4 to 6mm so the pin is longer enough but still will not extended past the handle.
The diameter of the pin used on the round knob is 6mm (.236"). after the rivet is removed, enlarge the hole using a size "B" drill bit (.238") or a 1/4" drill bit. the handle blank must have enough 'meat' to support this larger hole.
Proper Installation Requires the Use of Loctite BLUE 242.
Attaching the Knob to the Handle Blank:
Note: The bottom screw is LEFT Handed!
To attach the knob to the handle blank, you must first remove the top cap of the knob.Using 2 screw drivers, remove the bottom screw and small washer from the internal shaft.
Note: The bottom screw is LEFT Handed! Place a small amount of Loctite Blue 242 into the opening of the internal shaft and on the threads of the bottom screw.
Attach the screw thru the handle blank hole into the shaft. With 2 screw drivers, tighten the 2 shaft screws from both the top and bottom. Replace the top cap.
If Needed, Installation Notes Available Upon Request
Sales Tax: CA Residents Pay Sales Tax.